Please enter your email address to reset your password. An email will be sent with instructions to create a new password. If you do not receive an email, please check your spam folder.
Don't have an account?
Are you a subscriber but don’t have an online account?
Register for full online access.
Would you like to receive email from Hanley Wood Media’s family of brands and partners?*
Note to existing JLC Subscribers:
If you choose to use your Social Network, please ensure that the email address associated with your Social Network matches the email associated with your JLC Subscription.
Thank you for creating your JLC Online account! Your JLC subscription purchase has begun in a new window.
If you see this message, make sure your popup blockers are disabled and click here to relaunch the subscription window.
Congratulations! Please check your e-mail for confirmation to gain full access to JLC Online's free features.
Please create a nickname to post in the forums.
A.Harrison McCampbell, an architect and moisture-intrusion consultant in Brentwood, Tenn., responds: Your concern about through-fastening is justified - it makes little sense to apply a carefully waterproofed membrane and then poke it full of holes.
It is technically possible to put a railing on the roof that is held in place by gravity alone. A simple way to do that would be to weld each of the railing columns to steel base plates. But first check your local code to make sure that the area where the railing will go is clearly defined as a roof, not a deck. This will probably depend on how accessible it is to the building's occupants - whether it can be reached through a door, by climbing out a window, or only by using a ladder. If the area could be considered a deck under the code, the railing should conform fully with the code requirements for that application - anything less is asking for trouble.
Either way, make sure the roof itself is properly designed and built to last. Provide the structural deck with enough slope to allow water to flow away from the building the addition will be attached to - 1/8 inch per foot is a practical minimum - and toward the roof edge or drain. Install a fully adhered waterproofing membrane, making sure to terminate it properly by turning it up and under the main building's moisture barrier and extending it fully over the drip edges. If there is an access door, the deck level should be at least 4 to 6 inches below it so that there's enough vertical space to turn the membrane up, terminate it, and counterflash it with the overhang of the door sill.
Fencing and Railing
Q. What causes nail pops in asphalt roofing shingles? Where I live, in the South, this...
Q. Why are LVLs sized differently than framing lumber? I can understand the...
Using pervious concrete on a driveway can reduce runoff and meet many...
Please read our Content Guidelines before posting.
2015 Hanley Wood Media, Inc. All rights reserved.