Are you a subscriber but don’t have an online account?

Register for full online access.

 
 
 

More stories about Framing

  • Replacing a Rooftop Deck

    Pedestal supports and preassembled wood tiles simplify installation and maintenance.

  • Q&A: Mold on Framing Lumber

    Q: I occasionally receive framing lumber that has some mold on it. Will this mold continue to grow and cause rot once the wood is in the dry? Do I have to clean it off? I'm also concerned about customer perception.

  • Fiberglass Window Frames

    Fiberglass windows are stronger than vinyl, insulate better than aluminum, and cost less than solid wood, say manufacturers.

  • Removing a Structural Chimney

    Two summers ago I received a call from some homeowners who wanted to remodel their kitchen and, as part of the project, remove a brick chimney that ran up through the center of the house.

  • Working On a SIPs Roof

    A look at the techniques used to add skylights and thermal solar collectors to a foam-core roof.

  • Building a High-Performance Shell

    Advanced framing and exterior foam reduce conductive heat loss and provide good air-sealing opportunities.

  • Replacing a Wood Beam With Steel

    The LVL beam had been installed in an earlier remodel to replace structural partitions supporting the second floor. Since Cox knew that a flush steel beam could do the job just as well — but invisibly — he offered to include the swap-out in the contract.

  • Anthony Forest Products Glulam Beams

    Power Preserved glulam beams are treated with Cop-Guard, a solvent-based copper naphthenate formulation.

  • Wood-Steel Composite Beam?

    Q. We're considering through-bolting LVL lumber to both sides of a steel I-beam. We'd install the resulting composite beam flush at midspan in an existing floor system, with the LVL providing convenient nailing for joist hangers. Can we assume that the combined load-bearing values for LVL and steel...

  • Rockler Model 31166 Corrugated Fastener Nailer

    Rather than build frames in place stick by stick, some trimmers assemble door and window casings on the floor and shoot them into place on the wall.