Please enter your email address to reset your password. An email will be sent with instructions to create a new password. If you do not receive an email, please check your spam folder.
Don't have an account?
Are you a subscriber but don’t have an online account?
Register for full online access.
Would you like to receive email from Hanley Wood Media’s family of brands and partners?*
Note to existing JLC Subscribers:
If you choose to use your Social Network, please ensure that the email address associated with your Social Network matches the email associated with your JLC Subscription.
Thank you for creating your JLC Online account! Your JLC subscription purchase has begun in a new window.
If you see this message, make sure your popup blockers are disabled and click here to relaunch the subscription window.
Congratulations! Please check your e-mail for confirmation to gain full access to JLC Online's free features.
Please create a nickname to post in the forums.
Slicing and boring concrete can be fast and economical if you rent the right tools — or hire the right sub.
A high-end remodeler describes the finer points of tearing out: from hand-holding and bidding to shoring and jacking.
A woodworker builds a traditional New England cupola with a curved hip roof.
Not all 2,000-square-foot houses have the same usable living area. Here’s how professionals measure square footage.
CPM scheduling is a big-job technique that can pay off for the small builder as well. A management pro walks you through the basic techniques.
A few plumbing surprises can easily blow your estimate. A master plumber tells you what to look for on a pre-bid inspection.
Unit pricing is faster than stick bidding, and can be just as accurate. A remodeling expert tells how.
Q: What is the best way to tie the new slab floor of an addition to an existing slab-on-grade foundation?
Q: On a recent job we had trouble with rain water getting through the paper wrapping on some architectural grade glulam beams. How can the water stains be removed?
Q: Is there a paint or sealer that will encapsulate the smell of smoke on fire-damaged walls?
Q: I am planning to build with 12 inches or more of blown-in cellulose insulation in the ceilings. How much insulation can you put in a ceiling before the unsupported drywall between joists sags? I usually use 1/2-inch drywall with trusses 24 inches on-center.
Q: Can copper flashing be used with cedar shingles? I was told the natural oils in the cedar can corrode the copper.
Q: What is the best primer and paint for an unpainted stucco exterior?
2015 Hanley Wood Media, Inc. All rights reserved.