Please enter your email address to reset your password. An email will be sent with instructions to create a new password. If you do not receive an email, please check your spam folder.
Don't have an account?
Are you a subscriber but don’t have an online account?
Register for full online access.
Would you like to receive email from Hanley Wood Media’s family of brands and partners?*
Note to existing JLC Subscribers:
If you choose to use your Social Network, please ensure that the email address associated with your Social Network matches the email associated with your JLC Subscription.
Thank you for creating your JLC Online account! Your JLC subscription purchase has begun in a new window.
If you see this message, make sure your popup blockers are disabled and click here to relaunch the subscription window.
Congratulations! Please check your e-mail for confirmation to gain full access to JLC Online's free features.
Please create a nickname to post in the forums.
Fitting all the fixtures into a usable space is the main challenge of small bath design. A house designer describes her favorite small-space floor plans.
When a house frame shrinks, it can leave bumps and dips in the floor, cause doors to bind, and open cracks in drywall and casing joints. Proper selection of materials and attention to framing details can keep these problems to a minimum.
With so many types of glue on the shelf, how do you choose the right one? A long-time finish subcontractor explains which adhesives work best inside and out.
When a foundation is out of level, framers often need to shim or scribe floor joists to allow for high and low spots. Two second-generation contractors explain the methods that work for them.
A master electrician shows the tools and techniques he uses to snake new wires in old houses without causing excessive damage to finishes or trim.
The difference between one skylight and another is in the details. Here’s an overview of add-ons for roof windows.
Bootleg grounds, leaky ridge vents, stiff tile subfloor
Pier foundation failure, EIFS hides moisture problems, electrical code changes, termites versus foam
Q: Occasionally when we’re hanging a drop ceiling in a commercial building, we encounter a change in ceiling elevation. What’s the easiest way to deal with this transition?
Q: It is my understanding that plywood and OSB should always be installed with space between the sheets for expansion. Apparently, always isn’t always. I am just now beginning a project on an unfinished house in New England that has had the 1-inch OSB subflooring glued and nailed to the joists...
Contract protection from design flaws
Misaligned load paths
Kit for writing a business plan
Kitchen heating solutions
Drywall that bends, adjustable spring clamps, portable work table
New pneumatic trim nailers
2015 Hanley Wood Media, Inc. All rights reserved.