Please enter your email address to reset your password. An email will be sent with instructions to create a new password. If you do not receive an email, please check your spam folder.
Don't have an account?
Are you a subscriber but don’t have an online account?
Register for full online access.
Would you like to receive email from Hanley Wood Media’s family of brands and partners?*
Note to existing JLC Subscribers:
If you choose to use your Social Network, please ensure that the email address associated with your Social Network matches the email associated with your JLC Subscription.
Thank you for creating your JLC Online account! Your JLC subscription purchase has begun in a new window.
If you see this message, make sure your popup blockers are disabled and click here to relaunch the subscription window.
Congratulations! Please check your e-mail for confirmation to gain full access to JLC Online's free features.
Please create a nickname to post in the forums.
This basic trim detail turns an unspectacular cut into an eye-catcher.
From steel to plastic to custom wood, builders today have a wide range of garage doors to choose from.
A ventilation contractor explains the ducting, sizing, wiring, and balancing that produce an effective HRV installation.
Are powerful, multifunction construction software packages worth the cost and the time they take to learn? We look at five builders who took the leap and were willing to share their stories.
A builder describes an accurate, efficient method for figuring the cuts on irregular hip and valley rafters.
Mold controversy, state contract law, router kit clarification, universal PEX fitting, more
Builder optimism, panel roof problems, window latch recall, Business Tune-Up, more
Q: We’re building a three-story house with plywood sheathing that will be covered with EIFS. Because the house has 9-foot ceilings, the horizontal sheathing joints don’t fall near the band joist area. The EIFS rep says we have to plan for joist shrinkage by establishing a control joint, and he...
Q: The red cedar clapboard siding on a house in the Boston area was not backprimed and has typical moisture-related paint failure. It has been painted five times in 25 years. The house has no interior vapor barrier. I am considering removing the siding and installing new backprimed clapboards over...
Q: In a bathroom remodel, we plan to install a light fixture in a shower stall, with a switch near the shower door. Do the fixture and switch need to be GFCI-protected?
Q: Before installing vinyl siding over existing wood siding, we first install a layer of fan-fold foam insulation. Is the fan-fold foam an adequate weather-resistive barrier?
Q: How do I size the exhaust fan for a range hood above a gas cooktop?
Simple estimating system for small remodelers
Asbestos and the law
Algae on asphalt shingles
Bifold doors, pocket protector tool sheath, elastomeric masonry coatings, removable duct tape, more
Cordless compound miter saws
2014 Hanley Wood Media, Inc. All rights reserved.